Glock 44 Magazine Extension (+5rd)

Description

This extension uses stock Glock 44 magazine or promag and stock springs. Extension is 3D printed out of durable PETG material and adds 5 rounds to standard capacity. Must remove finger guides and spring bottom to get all 15 rounds into magazine. I will do custom paintjobs just message me what you are wanting.
Instructions:
1. Remove factory magazine bottom by pressing firmly on both sides of the magazine and pulling the baseplate off. (youtube has plenty of videos on this)
2. Remove the small tabs on each side of the magazine where the stock baseplate attaches. Razor blades work great for this.
3. Remove the finger guides on each side of the magazine.
4. Remove the piece attached to the bottom of the spring.
5. Slide magazine extension into place. Do not hammer it. If it is tight you can use a lighter to warm up each side and slide it onto the magazine with ease.
6. Complete.